Hot Foil Coder
Read More11 / 11
Adjusting the coder end stroke position - - Mini Synergy - Electric Type
Tools:
10mm & 8mm Wrench
Method
Loosen two side lock nuts
Adjust central turnbuckle
With Up in this Orientation being Clockwise the stop position is adjusted toward the label.
Counterclockwise would adjust the stop position away from the label.
This adjustment is used to get a good amount of pressure to transfer the ink of the ribbon at Temperature.
Too much pressure can damage the label
Too little pressure can result in an imprint that is too light or missing.
- No Comments