LabelOn Modular Manuals

Video: Re-Assembly Instructions for Overhead Swivel Controls

Notice there will be 3 cables with plugs that run through the swivel Controls Vertical Support Post
a) Locate and Remove Swivel Controls Limit Collar (Very Important Item to Fit Again)

b) Two people at least - Lift and Fit Vertical Post though Overhead Support Bracket ONLY
Do not sit it in its support Boot yet

c) Slide Swivel Controls Limit Collar back onto the Vertical Post (from the bottom up) - it can be loose at this stage as you still need to lower the vertical post into position

d) Seat Vertical Post of Swivel Controls into the Support Boot – Guiding the three cables with plugs through the hole in the base of the Support Boot
You should now be able to release the weight of the swivel controls Assembly

e) *** Important*** Now correctly Fit/Set the Swivel Controls Limit Collar. Failure to do this AT THIS STAGE can result in the Controls rotating too far and damaging the wires from the Controls to the Main Electronics

f) Connect the 3 cables with Plugs of the Swivel Vertical Post with Sockets on the Main Electronics Cabinet located under the Support Boot; there will be a cover that is on the underside of the Support Boot that you will need to remove and refit for this final step.

g) Locate and fit the Status Light Tower to the top of the Swivel Controls Cabinet

Share URL : https://goo.gl/g7QMwG